>See figure N\u00ba 1<\/em><\/strong><\/p>\n\n\n\n
4) To avoid rod bending, both pins at the ends of the actuator should be parallel each other. 5) To avoid rod bending, the fixed mountings at the ends of the actuator should have an U shape to achieve the strength to be centered with the actuator axis. 6) To achieve the actuator gets a free rotation during the piston extension, it is recommended that there is an enough gap between the mountings holes and the pins.<\/p>\n\n\n\n 7) It is important that the actuator supports are rigid enough to support the actuator start-stop torque. 8) To avoid premature wear or actuator jam, the pins set in the actuator end holes should be with good superficial finishing.<\/p>\n\n\n\n 9) To avoid jams produced by dust plus oil in the joint, it is important that the assembly the actuator moves is over-sized, and the customer actuator strength requirement are over-sized also.<\/p>\n\n\n\n 10) It is necessary for motor and circuit protection to put in the electrric circuit one thermal protector, polyswitch. For polyswitch sizing see the actuator particular section.<\/p>\n\n\n\n 11) Remember that Welact 1 family actuators get two microswitch inside the compact design. Due to, any assembly to be moved has two ends, upper and lower dead points. It is essential that any actuator microswitch (upper or lower) interrupts before the piston arrives the end of the assembly, otherwise the actuator will break by a short circuit.<\/p>\n\n\n\n
>See figure N\u00ba 2<\/em><\/strong><\/p>\n\n\n\n
>See figure N\u00ba 3<\/em><\/strong><\/p>\n\n\n\n
>See figure N\u00ba 4<\/strong><\/em><\/p>\n\n\n\n
![\"\"](\"https:\/\/imwsa.com\/wp-content\/uploads\/sites\/2\/2022\/07\/guia_01c1.gif\")
<\/figure>\n\n\n\n![\"\"](\"https:\/\/imwsa.com\/wp-content\/uploads\/sites\/2\/2022\/07\/guia_02c1.gif\")
<\/figure>\n\n\n\n![\"\"](\"https:\/\/imwsa.com\/wp-content\/uploads\/sites\/2\/2022\/07\/guia_03c1.gif\")
<\/figure>\n\n\n\n![\"\"](\"https:\/\/imwsa.com\/wp-content\/uploads\/sites\/2\/2022\/07\/guia_04c1.gif\")
<\/figure>\n","protected":false},"excerpt":{"rendered":"